BAHAMA® “Heater” – For permanent Jumbrella Installations. Designed to extend your outdoor terrace season by months.

Bahama Heating creates instantaneous heat sourced
from short wave infrared radiators. These custom
heaters are exclusive for Bahama products and are
completely TÜV certified. Even when left on for
extended periods of time, Bahama heaters will never
damage the umbrella’s membrane or structure.
Heating comes factory-prewired inside the major
column of your umbrella, leaving all wiring hidden from
view. 4 Heaters are
fixed on the frame's support spokes. Each umbrella
comes with its own external control box allowing
Heaters to be switched on or off individually.

On-site prerequisite required for the installation of any heater-equipped JUMBRELLA is a 400-volt/3-phase source for input into the ECU. Power output of the ECU to the 4 radiator units of the JUMBRELLA is on 230/240-volt AC. Connecting load requieed to operate any "Heater"-equipped umbrella is 8.1 kW (including 0.05 kW for "Light") per each Jumbrella Structure.

Nominal performance of each of the 4 TUV-certified (to IP65 - extremely humid-air operation standart) radiator unit is 2000 watts. Radiators furnish an isntant, simultaneously perceptible warmth generated by short-wave infrared eadiation. It is exactly the kind of infrared A-radiation that is used for medical curing purposes and wellness facilities as well.

Power consumption of any "Heater"-equipped JUMBRELLA model with radiator performance set to 100 percent is 8kW per operation hour. With the "Heater" equipment in its basic edition, performance below 100% can be set to 75, 50 or 25 percent by switching off each on, two or three of the four ON/OFF switches marked "H1" throug "H4" insied the External Control Unit (ECU). A two switches OFF settings, for instance, may make sense in the event that only one half of the seating area underneath the umbrella occupied. Contrary to this, the upgraded edition of the "Heater" equipment coming with both a primary ECU and its interconnected "External Dim-Control Unit" (EDCU) enables the infinitely variable control of each individual radiator within its range from zero to 2000 watts if the superposed collective switch inside the primary ECU is set to ON. The upgraded equipment allows the operator to be felxible in adapting the intensity of radiators to the wshes of guests underneath the JUMBRELLA.